Wiring The Power Supply - Siemens SINUMERIK 828D Manual

Connection
5.3 X1 power supply
Digital outputs
To supply (24 V DC) the digital outputs, an additional external power supply source is
required. The power supply is connected to terminals X111, X222 and X333 via pins 47, 48,
49 and 50 (DOCOMx). Ground pins must be connected to a common chassis ground.
Maximum current consumption: 3 x 4 A if all outputs are used simultaneously.
CAUTION
It is the user's responsibility to ensure that the max. current consumption per DOCOMx pin
(X111, X222, X333: Pins 47, 48, 49, 50) does not exceed 1 A. The power supply (+24 V
DC) for the digital outputs must therefore be connected to all 4 pins per DOCOMx (X111,
X222, X333: pins 47, 48, 49, 50).
Analog inputs/outputs
The inputs and outputs are supplied with power on-board, i.e. no further external power
supply units are required.
5.3.2

Wiring the power supply

Properties
This interface is intended exclusively for the connection of the external 24 V power supply.
On the module side, the power supplies are protected against:
● Polarity reversal
● Short-circuit (elec. current limitation of the outputs)
● Overload (self-restoring PTC fuse - Multifuse)
Pin assignment
Table 5- 3
Pin
1
2
3
Power requirement
0.7 A (at 24 V DC) for PP 72/48D 2/2A PN and digital inputs plus 3 x 4 A at X111, X222 and
X333 for supplying digital outputs.
22
Pin assignment at X1 screw-type terminal block
Signal name Signal type
P24 VI
M GND
PE GND
Meaning
24 VDC power supply
Ground
Protective ground
PP 72/48D 2/2A PN I/O module
Manual, 03/2010