Kwikset SmartCode 909 Installation And User Manual page 3

6
Add user codes (8 max)
Programming Timeout
If no button is pressed for five seconds, the system will time
out and you will need to restart the procedure.
A
Make sure the door is open. Press
the Program button the number of
times that corresponds to the user
code position being programmed.
Example: If
programming
the third code,
press the button
three times.
D
What lights and sounds does the lock produce?
One green flash with one beep*
green
Programming was successful.
*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon. See "Switches and Status LED Colors" on page 4.
Mastercode
For enhanced security, a mastercode may be used when adding and deleting user codes. For more information about the mastercode, download the Programming
and Troubleshooting Guide on the SmartCode 909 page at www.kwikset.com.
Test the lock (review normal operation)
7
Confirm that the code(s) added in previous step can unlock the door.
Locking the Door
Press Lock button once.
8
Re-key the lock (if needed) and install the battery cover
A
Re-key the lock (if needed).
a
K
IMPORTANT:
Remove
battery
pack before
re-keying.
B
Enter user code. A total of 8 user
codes may be programmed.
Three red flashes with three beeps*
or
1x
Make sure the user code is not a duplicate and that it is
between 4 and 8 digits during your next attempt.
b
Re-key the lock
to work with your
existing key. See the
supplied SmartKey
Re-key instructions
for more
information.
H
C
Each user code
must be a unique
code between 4
and 8 digits.
red
3x
Programming was unsuccessful.
Unlocking the Door
Enter user code.
Tip: You can press the
Lock button before
entering your user
code to light up the
keypad at night.
B
c
K
Reinstall
battery
pack.
3 / 4
Press Lock button once.
Two beeps*
or
2x
Programming time out.
Make sure not to pause for more
than 5 seconds during programming.
Install the battery cover.
a
b
M
actual
size
V
V (3x)