Kwikset HALO Installation And User Manual

67609-001
Rev 01
Installation and User Guide
Required tools
Ruler Phillips head screwdriver
Additional Tools (depending on application)
Hammer Wood block Chisel

Prepare the door and check dimensions

1
Make sure your door is compatible. If you have a standard deadbolt mounted
A
separately from the handle below it, your door is compatible.
Compatible Not Compatible
C Measure to confirm that the hole in the door is either
2-1/8" (54 mm) or 1-1/2" (38 mm).
Note: Additional door
2-1/8"
preparation may be
54 mm required for doors with
1-1/2" (38 mm) holes.
or
Consult the deadbolt
drilling instructions at
1-1/2"
kwikset.com/doorprep
38 mm
2

Install the latch and strike

A
Is the door edge chiseled?
YES
or
chiseled
Use latch "A". If the Use latch "B" (not
latch bolt is not already included). If the latch
extended, extend the bolt is not already
latch bolt as shown. extended, extend the
latch bolt as shown.
A
Kwikset
1-800-327-5625
www.kwikset.com
Not Compatible
Rim Mortise
Lock Lock
D Measure to confirm that the backset is
either 2-3/8" or 2-3/4" (60 or 70 mm).
b a
c k
s e
t
2-3/8" or 2-3/4"
60 or 70 mm
(2x)
For
Latch / Strike
Bag
03809
B
Hold the latch in front of the door hole, with the latch
face flush against the door edge.
NO
not
chiseled
A
C
Is the D-shaped hole centered in the door hole?
B
YES
D-shaped hole
No adjustment is required.
Proceed to next step.
1 / 4
Parts List
Mounting Adapter
Exterior Assembly
Plate Ring
Keys
Batteries
Latch A For Latch / Strike
Strike 03809
Latch B
46780
"B" is not included.
If needed, please contact
Kwikset to order a drive-in
latch for your lock.
If drilling a new door, use the supplied template and the complete
door drilling instructions available at kwikset.com/doorprep
B
Not Compatible
Integrated
Interior
E Measure to confirm that the hole
in the door edge is 1" (25 mm).
1"
25 mm
(2x) (2x)
46780
actual size
D
Which latch are you installing?
Latch "A"
B
NO
or
D-shaped hole
Rotate latch face as
shown to extend latch.
E
Install the strike on the door frame.
A
Make sure the hole in the door frame is drilled a
minimum of 1" (25 mm) deep.
B
Interior Assembly
For Lock
48654
SmartKey
Tool
49191 64109 68611
Remove your existing deadbolt
from your door.
F Measure to confirm that the door is between
1-3/8" and 2" (35 mm and 51 mm) thick.
1-3/8" –2"
35 – 51 mm
(2x)
actual size
Latch "B"
or
B
UP is
on top.
or
UP is
A
on top.
or
03809*
wood
(2x)
block
*Use longer
screws if
holes are
worn out.
Longer screws
install closest to
the door jamb.
46780
(4x)
door frame