Magnimage LED-500CD User Manual page 27

Multi-machine connection instruction
Multi " VGA2 <- 【OK】 -> ╳
machine is located in channel 2, port name is DVI, next to the"╳"that no valid signal
Fade In&Out under DVI input port; when the cursor is located in the channel 2 (The
Switch cursor on the right), use the"input port selection key"to switch the input
port of channel 1.
Use"LEFT"and"OK"button to make the channel 1 of current processor as
the multi-connection processor's output; use the"RIGHT"key to enable
the channel 2 of current processor as the multi-connection processor's
output.
Fade Period Combination switch sets signal input port switching process can experience
for 0 second to 5 seconds. If set to 0 seconds, then switching process would
be finished instantaneously.
Multi Can be set to"single"and"multi machine connection".
Connection Single：Not in the state of the multi-machine connection, that is, not in the
state of the combination switching.
Multi ： the state of multi machine connection, namely combination
switching state.
Range is 0~7，0 representing terminal machine, its previous level machine
Machine ID
Numbers is 1, the level before the previous is 2, and so forth.
Terminal, that is the video processor linking the LED sending card
Reset Press "RIGHT" or" OK" to reset the parameter in the multi machine
connection setting function.
DVI ", as shown in the left example, the cursor
25