Turn Signal/Wiper/Washer/High Beam Lever - Dodge CHARGER Hellcat 2017 User Manual

O P E R A T I N G Y O U R V E H I C L E
For the first 1500 miles (2414 km):
• Do not participate in track events, sport driving schools, or similar activities during the
first 1500 miles (2414 km).
NOTE:
Check engine oil with every refueling and add if necessary. Oil and fuel consumption may
be higher through the first oil change interval.

TURN SIGNAL/WIPER/WASHER/HIGH BEAM LEVER

Turn Signal/Lane Change Assist
Tap the lever up or down once and the turn
signal (right or left) will flash three times.
Then, it will turn off automatically.
Front Wipers
Intermittent, Low And High Operation
Rotate the end of the lever to the first detent
position for one of four intermittent set-
tings, the second detent for low wiper op-
eration and the third detent for high wiper
operation.
Mist
Rotate the end of the lever downward when
a single wipe is desired.
NOTE:
The mist feature does not activate the
washer pump; therefore, no washer fluid
will be sprayed on the windshield. The wash function must be activated in order to spray
the windshield with washer fluid.
Washer Operation
Push the end of the lever inward and hold for as long as spray is desired.
Rain Sensing Wipers
This feature senses moisture on the vehicle's windshield and automatically activates the
wipers for the driver when the switch is in the intermittent position. Rotate the end of the
lever to one of four settings to activate this feature and adjust sensitivity.
Rain Sensing can be turned on and off using the Uconnect System, refer to "Uconnect
Settings" in "Understanding Your Instrument Panel" in your Owner's Manual at
www.dodge.com/en/owners/manuals for further details.
70
Multifunction Lever
1 — Push For Washer
2 — Rotate Downward For Mist
3 — Push Lever For High Beams