Dodge CHARGER Hellcat 2017 User Manual page 192

W H A T T O D O I N E M E R G E N C I E S
7. Mount the spare tire.
Be sure to mount the spare tire with the valve stem facing outward. The vehicle could
be damaged if the spare tire is mounted incorrectly.
NOTE:
• For vehicles so equipped, do not at-
tempt to install a center cap or wheel
cover on the compact spare.
• Refer to "Compact Spare Tire" and to
"Limited-Use Spare" under "Tires—
General Information" in "Starting And
Operating" in your Owner's Manual on
www.dodge.com/en/owners/manuals
for additional warnings, cautions, and
information about the spare tire, its
use, and operation.
8. Install the lug nuts with the cone shaped end of the lug nut toward the wheel. Lightly
tighten the lug nuts.
To avoid the risk of forcing the vehicle off the jack, do not tighten the lug nuts fully until
the vehicle has been lowered. Failure to follow this warning may result in personal
injury.
9. Lower the vehicle to the ground by turning the jack handle counterclockwise.
10. Finish tightening the lug nuts. Push down on the wrench while at the end of the
handle for increased leverage. Tighten the lug nuts in a star pattern until each nut has
been tightened twice. The correct tightness of each lug nut is 130 ft-lbs (176 N·m).
If in doubt about the correct tightness, have them checked with a torque wrench by
your authorized dealer or service station.
NOTE:
For the SRT model the correct wheel nut tightness is 111 ft lbs (150 N·m).
11. Stow the wheel chocks, jack, tools and flat tire. Make sure the base of the jack faces
the front of the vehicle before tightening down the fastener.
A loose tire or jack thrown forward in a collision or hard stop could endanger the
occupants of the vehicle. Always stow the jack parts and the spare tire in the places
provided. Have the deflated (flat) tire repaired or replaced immediately.
190
CAUTION!
Installing Compact Spare
WARNING!
WARNING!