Table of Contents
Advertisement
Chapter 5 Switching Device Drivers
The procedure for switching device drivers is detailed below.
1. From your Desktop click Start – Programs – Lucent 20A-USB Modem – Configure.
2. Click Remove from the "ADSL Modem Installer" window.
3. A message will be displayed asking you to confirm the removal. Click Yes.
4. You will be prompted not to unplug the USB cable from your computer until after the
un-install process is completed. Click OK.
5. When the system has located the driver, you will be prompted to disconnect the CellPipe
20A-USB from your computer. Click OK.
6. The "Setup Complete" window will appear. Select to restart your computer. Click Finish.
7. Proceed to the Device driver installation section in Chapter 3 and follow the instructions
to load another driver.
.
CellPipe USB Series User's Guide
Chapter 5 Switching Device Drivers
15
Advertisement
Table of Contents
Need help?
Do you have a question about the CellPipe 20A-USB and is the answer not in the manual?