Carrier Zone Manager Owner's Manual page 5

Zone Manager
Switching on and day and hour settings
Setting the current time
• Press the " / " button.
SET TIME TEMP
The " " word blinks on the display for 15".
TIME
• Press the "up" or "down" button. The time will be displayed in
one of the following modes (consult the Zone Manager
installation manual):
- 12 hours with AM = morning, PM = Afternoon
- 24 hours
The time goes forwards or backwards by one minute at a time.
Holding the button down gives fast advance.
• Press the " / " button again to exit "
SET TIME TEMP
The word " " disappears from the display.
TIME
Setting the current day
• Press the " / " button.
SET TIME TEMP
The word " " blinks for 15 seconds.
TIME
• Press the " " button and stop on the desired day.
NEXT DAY
Successive days of the week are indicated on the display with
each press of the button.
• Press the " / " button again to exit "
SET TIME TEMP
The word " " disappears from the display.
TIME
NOTE:
If you choose not press the "
mode will automatically shut off after 10 seconds.
EXAMPLE:
To set Tuesday, time 15.32 (3.32 PM).
• Press " / " to enter day/time programming.
SET TIME TEMP
• Press "up" or "down" to set the time until "3:32 PM" appears
on the display.
• Press " " to set the day until "
NEXT DAY
display.
• Press " / " to exit day/time programming.
SET TIME TEMP
GB - 4
up
down
" mode .
SET TIME
" mode.
SET TIME
/ " button, "
SET TIME TEMP SET TIME
up
down
" appears on the
TU
"