General Information; Machine Characteristics; Main Design - lavina 20n-x User Manual

Superabrasive
1. GENERAL INFORMATION
This owner's manual is intended for the operator of the LAVINA® X machine, the servicing technician as well as anyone else
involved with operating or servicing the machine. We recommend that you read the instructions carefully and follow them
strictly.
The manual includes information about assembling, using, handling, adjusting and maintaining your LAVINA® X floor grinding
and polishing machine.
MANUFACTURER
Superabrasive was founded in 1987, as a manufacturer of high quality diamond tools for the stone and concrete industry. Today,
Superabrasive is one of the world's leading companies in the production of diamond tools and floor grinding machinery. At
Superabrasive, we strive to deliver the very best solutions to our customers, and enable them to work more efficiently.
GENERAL DESCRIPTION
The LAVINA® X machine is intended for grinding, polishing and buffing concrete, marble, granite, limestone and terrazzo surfaces
with diamond tools. Additionally, the machine could be used for grinding wood floor surfaces.
The LAVINA® X machine is a three‐disc machine, which can be used dry as well as wet.
For best results, use only tools manufactured or recommended by Superabrasive and its
distributors.
The LAVINA® X machine is manufactured and fitted for the above‐
mentioned applications only! Every other use may cause risks to the persons involved.
MACHINE CHARACTERISTICS
The LAVINA® X machine is made of two main component sections:
MAIN DESIGN
The two main component sections are the carriage and main head.
The handle (Fig.1.2) on the frame is adjustable in height and allows the operator to work in a
correct and safe working posture.
The halogen spotlight (Fig.1.2) enables the operator to work in darker areas.
Existing lighting system does not replace adequate overhead lighting.
The controls are positioned on top of the electrical box (fig.1.3)
The electrical box (fig.1.3) contains the electric switches and the inverter.
The main feeding cable is connected with a plug and socket on top.
The motor feeding cable is plugged into the socket located on the bottom of the box.
The tank is on the opposite side of the frame, so that the weight of the water has no influence on
the operation of the machine. The frame weight, on the other hand, is fully absorbed by the
driving wheels. An electric pump sprays the water through a front sprayer or internal.
The motor is mounted on the base plate and drives the three heads with a belt system.
The planetary head is driven by a second belt.
ENVIRONMENTAL CONDITIONS
The temperature range for operating the LAVINA® X machine
outdoors is between 41°F and
86°F or 5°C and 30°C. Never use the LAVINA® X machine during rain or
snow when working outdoors. When working indoors, always operate
the machine in well‐ventilated areas.
ELECTRICAL CONNECTION
The voltage (Volt) and current (Ampere) are displayed on a label on
the electrical control box to avoid any incorrect connection. Refer to
these before connecting the power. To avoid electrical shocks, make
sure the ground power supply is functioning properly.
User Manual Original Language Lavina® 20N‐X
Figure 1.3
5
6/2017
Figure 1.1
Figure 1.2