Kyocera FS-C5100DN Operation Manual page 30

>TCP/IP (IPv6) >
On
>>ICMPv6(NDP)
Off
>>DHCPv6
Off
>>Prefix Length
>>Prefix Length
Security
2-4
TCP/IP (IPv6)
1
This section describes how to enable the TCP/IP (IPv6) protocol.
If TCP/IP (IPv6) is set to Off, use
[OK] ([ENTER]).
2
Press . Each time you press
000
3
Display the item you want to set and press [OK] ([ENTER]). A
blinking question mark (?) appears while you are setting
000
ICMPv6(NDP) and DHCPv6. A blinking cursor (_) appears while you
are setting Prefix Length.
4
Press or
and DHCPv6.
For the Prefix Length settings, press
cursor to the number you want to change (000 to 128).
to move the cursor right and left.
Note Check with your network administrator for the network
address settings.
5
Press [OK] ([ENTER]).
6
Press [MENU]. The display returns to Ready.
NetWare, AppleTalk, IPP, SSL Server and IPSec settings
1
Press [MENU].
2
Press or
>
or
or , the selection changes.
to select On or Off as the setting for ICMPv6(NDP)
repeatedly until Security > appears.
to selecto On and press
or to move the blinking
Use and
Printing Operation