Pit Boss PB100P Instructions And User Manual page 18

Gusting Or
High Winds
Irregular Obstructed
Flame Burner Tube,
Pattern Burner Ports
Burner Poor Air Flow
Flames Are
Yellow Or
Orange
Obstructed
Burner Tube,
Burner Ports
Grease Tray Is
Full, Spilling
Onto Ground
Regulator
Valve Is Off
Burner Is Dirty Turn regulator knob to HIGH for five minutes, and
Grease Fire Cooking
/ Frequent Temperature
Flare-Ups
Grease Build-
Up On Burner
Components
Spiders & Obstructed
Flashback Burner Tube,
Fires Burner Ports
Gas Leakage Improper
Installation
Seal Failure
Regulator
Failure
18
Turn front of grill away from wind or increase flame
height.
Check burner tube and burner ports for spider webs
or other obstructions. Follow Care and Maintenance
instructions to clean the burner tube.
Check burner tube and burner ports for spider webs
or other obstructions. Follow Care and Maintenance
instructions to clean the burner tube.
Check burner tube and burner ports for spider webs
or other obstructions. Follow Care and Maintenance
instructions to clean the burner tube.
Empty grease tray and re-install. Follow Care and
Maintenance instructions.
Check the regulator valve connection to the gas
cylinder. Remove, then reinstall. Perform leak test.
burn-off the unit. Follow Care and Maintenance
instructions.
Attempt cooking at a lower temperature. Grease does
have a flash point. Keep the temperature under 176°C
/ 350°F when cooking highly greasy food.
Follow Care and Maintenance instructions.
Check burner tube and burner ports for spider webs
or other obstructions. Follow Care and Maintenance
instructions to clean the burner tube.
Turn the regulator knob to the OFF position, and
allow the regulator knob to pop out. Remove the gas
cylinder. Re-install and tighten. Perform leak test to
ensure proper seal. Replace gas cylinder if damaged.
Gas cylinder has corroded, rusted, or has been
mishandled. Replace gas cylinder.
Regulator needs to be replaced. Contact Customer
Service for a replacement part.