Advertisement
1.
Blow dust particles from the lens surface with an ear syringe.
2.
Using a lens cleaning solution (available from most camera stores) moisten a cotton
swab, cover the swab with lens paper and carefully clean the lenses and eyepieces. This
method may also be used to remove oily smears and fingerprints, which detract from the
image quality. Glass surfaces should be cleaned very carefully and only when necessary.
NOTE: All optical glass surfaces should be cleaned using a circular motion.
7.0
LAMP REPLACEMENT
If lamp replacement is necessary, follow these simple instructions: DANGER!!! Do not attempt to change
the lamp before allowing it to completely cool
7.1
TRANSMITTED (BOTTOM) ILLUMINATION
1.
Unplug the electrical cord.
2.
Carefully lay the instrument on its back and unscrew the base assembly
3.
Remove the old lamp, and insert the new lamp being careful to avoid leaving fingerprints
on the lamp surface.
4.
Reattach the base assembly. Do not operate the microscope unless the base is securely
attached.
7.2
INCIDENT (TOP) ILLUMINATION
1.
Unplug the electrical cord.
2.
Raise the body to the highest position by turning the focusing knob and lay the
microscope back on its arm.
3.
Unscrew the illuminator housing.
4.
Remove the bulb from the lamp socket in the lamp housing.
5.
Insert the new bulb into the lamp socket using care not to leave fingerprints on the bulb.
6.
Re-screw the lamp housing, and return the microscope to the upright position.
Replacement Bulb: Catalog No. 3363 for both top and bottom illuminators
ACCU-SCOPE Microscopes are carefully assembled, inspected and tested by ACCU-SCOPE personnel in
our New York facility. Careful quality control procedures ensure each microscope is of the highest quality
prior to shipment. This microscope is warranted to be free from defects in material and workmanship for a
period of five years from the date of invoice to the original (end user) purchaser. This warranty does not
cover damage caused by misuse, neglect, abuse, in-transit damage, or damage resulting from either
improper servicing or modification by other than ACCU-SCOPE approved service personnel. This
warranty does not cover any routine maintenance work or any other work, which is reasonably expected to
be performed by the purchaser or by normal wear. No responsibility is assumed for unsatisfactory operating
performance due to environmental conditions such as humidity, dust corrosive chemicals, deposition of oil
or other foreign matter, spillage or other conditions beyond the control of ACCU-SCOPE INC. This
warranty expressly excludes any liability by ACCU-SCOPE INC. for consequential loss or damage on any
grounds, such as (but not limited to) the non-availability to the End User of the Products under warranty or
the need to repair, work processes. All items returned for warranty repair must be sent freight prepaid and
insured to ACCU-SCOPE INC., 73 Mall Drive, Commack, NY 11725 – USA. All warranty repairs will be
returned freight prepaid to any destination within the Continental United States of America. Charges for
repairs shipped back outside this region are the responsibility of the individual/company returning the
merchandise for repair.
ACCU-SCOPE is a registered trademark of ACCU-SCOPE, Inc., Commack, NY 11725
LIMITED MICROSCOPE WARRANTY
4
Advertisement
