Table of Contents
Advertisement
STEP# 3 FRONT (WHITE) REFLECTOR
NOTE: For your convenience, your front reflector may have been pre-assembled to
the handle bar at our factory.
1. Remove the clamp screw from the reflector bracket
2. Push open the bracket "loop" and slide it onto the
handlebar (If there is a sizing insert included with
the bracket, please be sure it is inside the clamp
loop before mounting.)
3. Position the reflector bracket in the middle of the
handle bar.(see the picture)
4. Tighten clamp screw securely.
CAUTION: Be sure the reflector is in the same longitudinal plane
as the bicycle (horizontal to the ground). If the reflector is aimed up
or down, oncoming headlights may not reflect properly in the reflector.
I
f the reflector is not horizontal t
angle. Tighten adjusting screw securely.
NOTE:PLEASE ADJUST THE HEIGHT OF HANDLE BAR AS PHOTO, TO AVOID
REFLECTOR BE BLOCKED BY BASKET.
STEP# 4 REAR (RED) REFLECTOR
NOTE: For your convenience, your rear reflector may have been pre-assembled to
the fender at our factory.
Attach the molded reflector to the rear
fender in place, tighten the clamp
screw with washer and nut and
ensure that it is upright and facing
away from the bike.
(see the picture)
STEP# 5 WHEEL REFLECTORS
NOTE : FAILURE TO MOUNTAND DISPLAY THE REFLECTORS SUPPLIED COULD CONSTITUTE A VOILATION
OF THE LAW WITH YOUR CITY OR STATE FOR YOUR SAFETY. PLEASE MOUNT ALL REFLECTORS AS
INDICATED. FOR ADDITIONAL NIGHT RIDING SAFETY AND TO COMPLY WITH THE LAWS OF MANY CITIES
AND STATES, YOUR BIKE SHOULD BE EQUIPPED WITH HEAD AND TAILLIGHTS. FOLLOW INSTRUCTIOS
ACCORDINGLY. YOU WILL RECEIVE EITHER TYPE A OR TYPE B WHEEL REFLECTORS.
1.
Position the reflector between the left and right layers of spokes
opposite the valve stem.
2.
Then slide notch in circle of reflector onto spoke slide the
reflector as close to the wheel rim as possible without bending
spokes.
3.
Push slot in white cap over spoke so the flanges fit into large
slots in circles. Twist white cap towards the right with a flathea
crew driver as far as possible. Reflector should be secure.
NOTE: When assembled, the distance from the center of the reflector
to the inside of the wheel rim must be less than 3" (7.62cm).
o the ground, loosen the adjusting screw and readjust the
Rear
Reflector
Tab in bottom hole
6
.
Stem
Screw in top hole
Fender
Washer
Nut
8mm
Wrench
Advertisement
Table of Contents
