Table of Contents
Advertisement
PUTTING YOUR BIKE TOGETHER
REMOVE BIKE FROM CARTON
Be sure all parts are removed from carton. Check before you discard the carton. Remove all
protective packing material.
STEP# 1 – ASSEMBLE THE FRONT WHEELTO FORK
1.
Turn the fork until the fork
Plate points to the front of the
Bicycle. (See illustration A)
2.
Insert the wheel into the
fork.
3.
Install an axle nut to each
side of the axle.
(see illustration B)
4.
Tighten the axle nuts by
hand. Make sure there is an
equal distance between each
fork tube and the wheel.
Then use a wrench and
securely tighten the axle nuts.
(See illustration C & D)
TORQUE REQUIREMTNTS
(SEE PAGE 15)
STEP # 2 KICKSTAND
TYPE 2A - NOTE:FOR YOUR CONVENIENCE,YOUR KICKSTAND MAY BE
PREASSEMLED AT THE FACTORY.
1.
Place the right side (sprocket side) of
the bike against a wall or have someone
hold the bike for you.
2.
Remove the rear axle nut and washer
from the left side rear wheel.
3.
Slide the kickstand plate onto the axle,
so that it is seated against the rear
dropout.
4.
Slide the washer and nut back onto the
axle and tighten securely.
5.
Leave the kickstand leg down so it will
support the bike during the rest of the
assembly process.
CAUTION: THE KICKS
SUPPORT THE BICYCLE ONLY, NOT THE
BICYCLE AND RIDER.
TAND IS DESIGNED TO
5
Advertisement
Table of Contents
