Table of Contents
Advertisement
STEP # 8 INSTALL PEDALS
WARNING: For safe operation, the pedal spindle
must be securely tightened against the crank arm.
Always replace damaged pedals, and always wear
shoes or sneakers when riding a bicycle.
NOTE : Start each pedal spindle by hand to avoid
stripping the threads.
1.
Look for the letters "R" or "L" stamped on the
pedal spindle.
2.
Thread the pedal marked "R" into the crank arm
on the "chain side" of the bike. Turn the pedal
spindle in a clockwise direction. Securely tighten
the pedal spindle.
3.
Thread the pedal marked "L" into the crank on
the left side of the bike. Turn the pedal spindle in
a COUNTERCLOCKWISE direction. Securely
tighten the pedal spindle.
NOTE: Both pedals should be tightened towards
the front of the bicycle.
TORQUE REQUIREMENTS 18-20 ft.Ibs. or 20-26 N.M
STEP # 9 INSTALL SEAT POST AND SEAT
NOTE: your saddle has been pre-assembled to the seat post at our factory.
Please use this information for adjustment and future reference.
1.
Loosen seat clamp nuts.
2.
Insert the top portion of seat post
into the seat clamp. Be sure seat
post is completely inserted into the
seat clamp and butted tightly against
the end stop.
3.
Retighten seat clamp nuts on both
sides (Hand tight). These nuts will
be tightened later with an adjustable
wrench.
4.
Insert seat post into bicycle frame.
Be sure that seat post is inserted into
frame at least 2 1/2" (65mm).
CAUTION: MININUM INSERTION LINE SHOULD BE COMPLETELY INSERTED INTO
FRAME AND NOT VISIBLE.
8
Advertisement
Table of Contents
