Table of Contents
Advertisement
The correct frame size is the largest frame that the rider can automatically straddle keeping both
feet on the ground and allowing 25 mm (1 inch) clearance between the rider's crotch and the top
of the frame tube (see illustration) Noted Ladies can use men's bicycle to determine their correct
frame size.
Rider must be able to straddle bicycle with at least 1 inch (2.54cm) clearance above the
horizontal bar when standing.
UNPACKING
Important: Remove the bicycle and all parts from the carton. Lay out all unassembled parts
and READ THE ASSEMBLY INSTRUCTIONS In this manual before assembling our bicycle.
The instructions are a step by step procedure. Follow the steps that pertain to your model.
NOTE: Your bicycle may be equipped with a different component than the one illustrated.
However, the procedure for assembly or adjustment is basically the same.
RECORD SERIAL NUMBER
Note: This information is only available on
the bicycle itself. Be sure to keep your
own record of this number. Each bicycle
has a serial number stamped into the
bottom of the frame or on the rear fork plate.
(See illustration) Record this number on
page 2 of your owner's manual to keep it
for future reference.
TOOLS REQUIRED FOR ASSEMBLY
7mm Phillips screw driver
Standard slip joint pliers
2 in 1 of 5mm & 6mm Allen wrenches and open end set of metric flat wrenches 6"(15 cm) and 10" (25.4
cm) Adjustable wrench (Or Open End Set Of Metric Flat Wrenches). These tools should be available to
perform the basic steps of assembling the bicycles. They can also be used to make maintenance
adjustments outlined in this manual. Special tools are required to disassemble chain, remove the rear
hub parts and true wheels. Special tools are not required for assembly and normal maintenance.
NOTE: Use a hand or foot pump to Inflate tires. Never inflate tire with an air compressor at a
gas station. WARNING: IMPROPER INFLATIOIN IS THE BIGGEST CAUSE OF TIRE
FAILURE. DUE TO THE SLIGHTLY POROUS NATURE OF BICYCLE INNER TUBES, IT IS NORMAL
FOR YOUR TYRES TO LOSE PRESSURE OVER TIME. FOR THIS REASON, IT IS CRITICALLY
IMPORTANT TO MAINTAIN THE PROPER TIRE INFLATION ON YOUR BIKE.
Many bicycles are sold unassembled in cartons. For these bikes it is the responsibility of the
owner to make sure the assembly instructions in this book are followed exactly. For bicycles
that are purchased in an assembled condition, it is the responsibility of the owner to carefully
check and test the bike. The bicycle product does not provide above tools.
7mm flat edge screw driver
hammer
Torque Wrench Set
4
Advertisement
Table of Contents
