Table of Contents
Advertisement
1 Introduction
1.5.6.2 Enabling Ip Classless
IP config>classless
IP config>list ip-protocol
Directed broadcasts: enabled
RIP: disabled
OSPF: disabled
Multipath: disabled
Ip classless: enabled
Icmp redirects: enabled
Icmp unreachables: enabled
IP config>
1.5.7 Adding ID static routes
This last step configures the routes with identifier which link the IP destinations with the Dial Routing interfaces con-
nections. To do this a route to the destination address/subnet is created with the gateway being the Dial Routing in-
terface used for access together with the identifier corresponding to the Dial Routing connection. This connection
should be used to connect to the device providing access to the said network.
In this example, a route with identifier has been created for branch 1 towards network 1.1.1.0, with mask
255.255.255.0, whose gateway is the dialroute1 interface and whose identifier is 1, as this is the connection created
with the parameters to access branch 1. A similar process is carried out with the rest of the branches and the result
is shown below:
IP config>id-route 1.1.1.0 255.255.255.0 dialroute1 1
IP config>id-route 2.2.2.0 255.255.255.0 dialroute1 2
IP config>id-route 3.3.3.0 255.255.255.0 dialroute1 3
IP config>id-route 4.4.4.0 255.255.255.0 dialroute2 4
IP config>id-route 5.5.5.0 255.255.255.0 dialroute2 5
IP config>
Note
For further information on configuring IP, please see manual ALU-Dm702-I TCP/IP.
1.5.8 Configuration Summary
Lastly, we are going to display the definitive device global configuration in text mode for our scenario. This configura-
tion can be used as a base to carry out any required modifications and to send the resulting commands sequence to
the device in order to obtain the required configuration. This configuration does not include the multilink config-
uration.
Config>show config
; Showing System Configuration for access-level 15 ...
; OA5058 Router
log-command-errors
no configuration
add device ppp 1
add device ppp 2
add device ppp 3
add device ppp 4
add device dial-routing 1
add device dial-routing 2
set data-link at serial0/0
set data-link at serial0/1
set data-link x25 serial0/2
global-profiles dial
; -- Dial Profiles Configuration --
profile DIALROUTING default
profile DIALROUTING inout
profile DIALROUTING idle-time 70
;
exit
;
26
Alcatel-Lucent Enterprise
Dial Routing
Advertisement
Table of Contents
