Avaya 8600 Technical Manual page 46

Dest/Mask : 10.100.100.3/255.255.255.255
Out Label : 100640 ; Out Port : Vlan 1010 ; Next-Hop : 10.92.101.1
Type : ldp-dynamic
5 out of 5 Total number of FTN entries.
Step 2 – Use the following command to specify a specific path, for example, to ERS8600-1 CLIP address
ERS8600-2:5# show mpls ftn info 10.91.1.1/32
NNCLI: ERS8600:5# show mpls ftn 10.92.1.1/32
Result:
Dest/Mask : 10.91.1.1/255.255.255.255
Out Label : 100704 ; Out Port : Vlan 1010 ; Next-Hop : 10.92.101.1
Type : ldp-dynamic
1 out of 5 Total number of FTN entries.
Step 3 – To test if the MPLS path is operation, i.e. to 10.91.1.1/32, enter the following command
ERS8600-2:6# mplsping ipv4 10.91.1.1/32 count 3
NNCLI: ERS8600:5# ping-mpls ipv4 10.91.1.1/32 count 3
Results:
Label Switched Path to FEC 10.91.1.1/32 is operational.
ERS8600-2:6# mplsping ipv4 10.91.1.1/32 count 3
Success for FEC 10.91.1.1/32: mpls_seq=1.
Success for FEC 10.91.1.1/32: mpls_seq=2.
Success for FEC 10.91.1.1/32: mpls_seq=3.
Label Switched Path to FEC 10.91.1.1/32 is operational.
------ MPLS PING Statistics------
3 packets transmitted, 3 packets received, 0% packet loss
Step 4 – Enter the following command to display the MPLS ―In label‖, for this example, from ERS8600-1
ERS8600-2:5# show mpls ilm info
NNCLI command: ERS8600:5# show mpls ilm
Result:
In Label : 16 ; Out Label : N/A
Next-Hop : Interface : N/A ; Address : N/A
July 2010
IV-VPN (MPLS) for ERS 8600 Technical Configuration Guide
avaya.com
46