Table 4 Pv Status; Table 5 Device Status - Honeywell XYR 6000 User Manual

PV status
(blank)
BAD
BAD CONFIG
BAD E FAIL
UNC
Transmitter Wireless Builder display
display
OUT SVC OOS
SENS ERR Sensor Error
CHAR ERR Characterization Error
OVR TEMP Over Temperature
Revision 8
November 2010
 PV is normal – no action required
 Possible calibration error – Clear calibration
AITB can not execute due to internal firmware state – Attempt cold restart of

device.
AITB can not execute due to hardware fault – Replace sensor board

 Sensor failure – Check Connection between Sensor board and Meter Body.
 Meter Body Characterization Data is Bad – Replace Meter Body
Meter Body A/D Failure – Replace Meter Body

 Meter Body Sensor Fail – Replace Meter Body
 Configuration is bad – Check possible units and range settings for input type
and correct AITB configuration.
 Hardware fault detected - Replace sensor board
 Warning: Calibration (zero or trim) is causing excessive adjustment to
characterization value.
 Warning: Input inaccurate due to uncertain input data integrity.
Warning: Input inaccurate due to input conversion limitations or resolution.

 Warning: Input outside of characterized range. Value is estimated.

Table 5 Device status

OneWireless XYR 6000 Pressure Transmitter R120 User's Manual

Table 4 PV status

Cause - Action
Definition
All channels are out of
service.
Sensor can not access
meter body A/D
converter.
Sensor can not access
meter body
characterization or the
characterization is
invalid.
The meter body has
exceeded the maximum
temperature as defined
by the meter body
characterization data.
5. Operation
5.3. Transmitter PV display
What to do
Restore mode to Auto in Wireless
Builder.
Check connection between sensor
module and meter body. If still
doesn't work, replace sensor. See
page 32.
Check connection between sensor
module and meter body. If still
doesn't work, replace sensor. See
page 32.
Determine cause excessive
temperature.
17