Care Instructions; Removing Trim For Cleaning - Safety 1st Summit ISO 30 Manual

Care and Maintenance
• Seat trim may be removed for cleaning. Don't forget to remove the
instruction manual.
• Machine washable on lukewarm setting - delicate cycle.
• Tumble dry 10-15 minutes on low heat.
• Do not dry clean.
• All other surfaces should be cleaned with a mild soap and water.
• Never clean with bleach or spirit-type cleaners.
• Do not use the restraint without the cover.
• Check the webbing for fraying.
SPLITTER
PLATE
FEED STRAPS
OVER BAR
NOTE: ENSURE HARNESS IS NOT TWISTED
Take extra care to be sure the harness is reinstalled correctly and the
shoulder straps are of equal height through both the trim and the harness
slots of the seat.
TO REMOVE SEAT TRIM:
1. Loosen the harness by pressing down on centre
front adjuster.
2. Turn seat around and undo shoulder straps from
the splitter plate (Figure 3a).
3. Pull straps through the cover.
3a
4. Undo the buckle and remove the seat trim.
NOTE: Never wash air protect cells.
TO REPLACE SEAT TRIM:
1. Pull the seat trim on the seat.
2. Feed the shoulder straps through the harness
slots, over the top of the metal bar (Figure 3b).
3. Attach the shoulder straps to the splitter plate.
3b
37