Configuring Harness Straps - Safety 1st Summit ISO 30 Manual

Preparing Infant Seat To Fit Your Child
You MUST make these adjustments with your child before you install
the child restraint in the vehicle. Please adjust harness according to
the infant's shoulder height prior to installation.
PULL
IMPORTANT: ALWAYS ENSURE THAT THE HARNESS ADJUSTER IS FREE
FROM ANY OBSTRUCTIONS TO AVOID HARNESS STRAPS LOOSENING.
Strap can
be next
slot above
Child
shoulders
Strap cannot
be more than
25mm below
24
CONFIGURING THE HARNESS STRAPS
FOR CORRECT CHILD FITMENT
1.
2.
3.
PUSH
4.
5.
Shoulder
strap
Push the harness release lever at the front of
seat.
Pull the shoulder strap to loosen
Press red button to release buckle assembly
for ease of child fitment. Pull harness straps
over sides of infant seat. Place child in seat.
Fasten buckle assembly. Listen for "click!".
Pull strap to tighten.
REARWARD-FACING
(Newborn to approximately 30 months)
The shoulder straps must be in the slots which
are nearest to the child's shoulders, but not
lower than the child's shoulders.
FORWARD-FACING
(12 months to 4 years)
The shoulder straps must be in the slots which
are nearest to the child's shoulders, but not
more than 25 mm below the child's shoulders.