Coin Vend Interface - Sharp MX-B382 Technical Handy Manual

SHARP
All MX series machines have a coin vend interface located on the PCU Main PWB. The vending device
activates various signals to indicate paper sizes and operation.
Before connecting a third party auditor, the device should confirm to the following:-
1. The auditor interface should be optically isolated from the copier.
2. The device should be Power Supply Unit independent.
3. The device power supply unit should be a plug top adapter, not internal.
4. The plug top adapter should have a reinforced insulation barrier.
5. The audit device MUST comply and display the relevant safety approval mark (C-Tick, CE
or equivalent).
To enable coin vend function, test simulation 26 –03 should be set as required:-
Coin Vendor Mode
The specified
Diagnostic
Remainder of money
Setting
Condition 1
MODE 1 Operation 1
MODE 2 Operation 1
MODE 3 Operation 1
OPERATION 1 Wait for auto clear setting time
OPERATION 2 Auto clear is not made.
OPERATION 3 Setting is immediately cleared.
Connector Manufacture:
Connector Type
Connector Part Code (Wire Side)
quantity is
Black/Colour
completed.
is left
(Default 60sec – can be changed by the system setting)

COIN VEND INTERFACE

Insufficient money during copy job
(No money (Remainder of
remaining)
Condition 2
Operation 2
Operation 1
Operation 3
JST (www.jst.com)
PND series
PNDP-16V-Z
The specified
quantity is
Colour
completed.
money left)
Condition 3 Condition 4
Operation 2 Operation 1
Operation 2 Operation 1
Operation 2 Operation 3
No money
remaining
Cont'd
19