Lenovo ThinkPad P70 User Manual page 85

Table 2. Config menu items
Menu item
Network
USB
Submenu item
Wake On LAN
Ethernet LAN Option ROM
(for Legacy Only boot
mode or Both with Legacy
first)
UEFI IPv4 Network Stack
(for UEFI Only boot mode
or Both with UEFI first)
UEFI IPv6 Network Stack
(for UEFI Only boot mode
or Both with UEFI first)
UEFI PXE Boot Priority
(for UEFI Only boot mode
or Both with UEFI first for
boot capability and IPv6
and IPv4 stacks are both
enabled.)
USB UEFI BIOS Support
Value
• Disabled
• AC only
• AC and Battery
• Disabled
• Enabled
• Disabled
• Enabled
• Disabled
• Enabled
• IPv6 First
• IPv4 First
• Disabled
• Enabled
Chapter 6
Comments
Enable the computer to
power on when the
Ethernet controller receives
a magic packet (a special
network message).
If you select AC Only,
Wake on LAN is enabled
only when the ac power
adapter is attached.
If you select AC and
Battery, Wake on LAN is
enabled with any power
sources.
Notes:
• The magic packet type
Wake on LAN requires
ac power.
• The Wake on LAN
function does not work
when a hard disk
password is set.
Load the Ethernet LAN
Option ROM to enable
startup from an integrated
network device.
Enable or disable Internet
Protocol Version 4 (IPv4)
network stack for UEFI
environment.
Enable or disable Internet
Protocol Version 6 (IPv6)
network stack for UEFI
environment.
Select network stack
priority for UEFI PXE boot.
Enable or disable boot
support for USB storage
devices.
.
Advanced configuration
67