Install The Wall-Mount Bracket - enphase AC Battery Installation Manual

2. Install the Wall-Mount Bracket

a. Make sure that the wall-mount bracket matches the wall stud spacing and that the lowest wall-
mount bracket position meets clearance requirements as shown.
WARNING! Risk of injury and equipment damage. Protect the AC Battery from damage and
improper use.
b. Remove the appropriate knockout(s) for the planned entry into the wall-mount bracket junction box:
 If wiring inside the walls, use the knockout(s) in the back of each junction box. If using conduit,
use the knockouts at the bottom of the junction box.
If installing only one battery or if installing the last battery in an array, use only one knockout.

 Loosen the screw securing the junction box cover and remove the cover. Keep the cover handy
as you will need it
later.
c. Starting at battery
position closest to the
power source, mark a
level line on the wall as a
guide.
WARNING!
Multiple risks.
Make sure not to
drill or attach into
electric wiring or
pipes that are in
the wall!
d. Place the wall-mount
bracket on the wall so
that the mark on the
bracket aligns with the
center of the stud. Use a
level to keep the top of
the wall-mount bracket
flat, and attach each
corner of the wall-mount
bracket using one screw
and washer for each slot.
e. Verify that the wall-mount bracket is solidly attached to the wall.
WARNING! Risk of injury and equipment damage. Do not mount an AC Battery on a bracket
that is not properly mounted.
If installing additional batteries, install the adjacent wall-mount brackets in an interleaved fashion, as
f.
needed. Be sure to align the mark on the adjacent wall-mount bracket to the center of the wall stud.
A small overlap in adjacent wall-mount brackets is normal. You may install another row of wall-
mount brackets above the one already installed. Maintain at least one foot (300 mm) clearance
between rows.
11
© 2016 Enphase Energy Inc.
AC Battery Installation
141-00036 Rev 01