Subaru STARLINK Manual page 8

INTRODUCTION
NOTE
Fuji Heavy Industries is not responsible for any damages to the
l
purchaser or third parties that occur from using the map data.
We do not provide any replacements or refunds for any mistakes
l
there may be in the map data displays or contents, such as
misspelling, omissions or misaligned positions.
Fuji Heavy Industries makes no guarantee that the functions
l
included in the map data will be appropriate for the specific
objectives of the purchaser.
Functions that cannot be operated while driving have their
l
colours toned down when the vehicle is being driven, and their
operation is disabled. Touching a disabled switch may result in
the display of an operation prohibited message on the screen.
During strong vibrations, such as when driving on a poor road
l
surface, the unit may no longer be able to read the data from the
disc, and it will not operate correctly. When the vibration lessens,
normal operation will return after a short time.
Immediately after turning on the heater when the temperature
l
is low, dew (water drops) may adhere to the lens of the CD
reader (condensation). If this happens, leaving the unit for about
an hour should remove the condensation and return the unit to
normal operation.
If the unit does not return to normal operation even after several
hours, contact your SUBARU dealer.
When using the unit for the first time after purchase, or after
l
the battery was removed for a long time, the current position
may not be displayed correctly. Wait a short time until the GPS
positioning corrects the displayed position.
This device is precision-engineered equipment and the recorded
l
data can be lost as a result of static electricity, electrical noise,
vibration, or other influences. To protect the device against data
loss, we recommend keeping a separate record of the data that
you record after purchase.
8
NOTE
The screen may be adversely affected or disturbed by noise if
l
electrical equipment that generates powerful electrical noise
is used near the system. In such cases, keep the electrical
equipment at a distance, or refrain from use.
The display may appear brighter when the temperature is low,
l
or immediately after starting the engine, however, this is a
characteristic of the LED elements, and does not indicate a fault.
The display will return to its original brightness when the vehicle
cabin has warmed up.
When you look at the screen through polarized material such
l
as polarized sunglasses, the screen may be dark and hard to
see. If so, look at the screen from different angles, adjust the
screen settings on the general settings screen or take off your
sunglasses.
It may be difficult to view the screen if the display is exposed to
l
sunlight from an awkward angle.
The LCD screen may not function normally if covered with a
l
protective film. Do not affix a protective film.
The touch panel may function incorrectly or fail to respond if
l
operated with objects other than fingers (nails, operation when
wearing gloves, pens, etc.)
When inserting or removing CDs, take care not to touch the
l
touch panel. The touch panel will respond if inadvertently
touched by hand.
If the system functions unexpectedly such as an area other than
l
the one touched being selected, or failure to respond when
touched, there is a possibility that another finger or part of the
hand is in contact with display.
Scratches on the system panel surface are easily noticeable,
l
and it should therefore be handled with care.