Subaru STARLINK Manual page 7

l If direct sunlight shines into the vehicle, light may reflect off
the product. Be very careful while driving.
l Never use headphones or earphones while driving. Driving
while not being able to hear sounds from outside the vehicle
may result in a traffic accident.
CAUTION
l Although the unit can be used when the ignition switch is set
to either "ACC" or "ON" position, to protect the battery, start
the engine before using the unit.
l Do not use the unit anywhere other than in a vehicle. Doing so
may result in an electric shock or other injury.
l While driving, keep the volume low enough for you to hear
outside sounds. Driving while not being able to hear sounds
from outside the vehicle may result in an accident.
l Be careful of the volume when turning on the power. If a loud
noise is emitted suddenly when you turn on the power, it may
damage your hearing.
l Do not apply a strong force to the display. Doing so may result
in a malfunction.
l Do not put your fingers or hands into the disc slot. Doing so
may result in an injury.
l Do not touch the hot parts of the unit. The hot parts may burn
you.
l Do not use while there is an abnormality such as sound
breakup or distortion. Doing so may result in a fire.
l Using the unit during extremely high or low temperature may
result in mistaken operation or a malfunction. In particular, the
temperature inside the vehicle can often rise to a high level
during the summer. Cool the vehicle, for example by opening
a window, before using the unit.
l Be careful if metal or water enters the unit, or the unit is
exposed to a strong impact, because it may result in a
malfunction.
l The touch buttons on the display screen may not operate
correctly if condensation forms inside them. If this happens,
do not attempt to operate the switches until the condensation
has disappeared.
l If juice or similar liquid is spilled on the display, wipe
off immediately. Failure to do so may result in product
malfunction.
l The screen is easily marked by fingerprints and tends to
attracts dust, and should therefore be cleaned occasionally.
When cleaning, turn off the power, and wipe lightly with a soft,
dry cloth. To remove dirt, soak a soft cloth in neutral detergent
and squeeze well before wiping. Do not use a wet floor-cloth,
organic solvents (benzene, ethanol, thinner, etc.), acids, or
alkalis. Using such agents will result in screen deterioration.
Furthermore, do not hit the screen or rub it with hard objects.
INTRODUCTION
7