Nimh/Nicd Battery Program - HITEC X2 AC Plus Black Edition Manual

NiCd/NiMH Battery Program
NiCd/NiMH:
This program is only suitable for charging/discharging NiCd/NiMH batteries. The
X2 AC Plus Black Edition offers the following NiCd/NiMH charge modes: Charge,
Auto Charge, Discharge, Re-Peak and Cycle.
Selecting the Battery Type:
After powering on the X2 AC Plus Black Edition, press the ■ button repeatedly
until you reach the Appropriate program for the battery type you wish to charge.
For this example we have chosen the "NiMH BATT" or "NiCd BATT"program. Now
press the ► button to enter the desired program.
NiCd/NiMH Charge Mode:
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
Warning
INFORMATION CONTAINED ON PAGES 02-07.
After selecting the correct battery type, if the screen does not read "CHARGE",
use the + or ▬ buttons to change it to the "CHARGE" mode.
NiMH CHARGE
CURRENT 1.3A
desired rate. Follow the instructions provided with your battery when setting the
amperage rate.
Press and hold the ► button to begin charging.
NiMH 1.3A 5.42V
CHG 002:22 00106
charging current, battery voltage, charging time and charged capacity. Once
the battery is fully charged, the screen will read "END: FINISH" and the charger
will emit a chiming sound. You can press the ■ button at any time during the
charging process to stop charging.
Press the ► button and the amp rate value will begin
flashing. Use the + or ▬ buttons to adjust the value to the
Once charging has commenced, the charger will display
the following real-time information: battery type,
27