Lithium Battery Program [Lipo/Lihv/Life/Lilon] - HITEC X2 AC Plus Black Edition Manual

Ac/dc dual balance charger/discharger power supply
Hide thumbs Also See for X2 AC Plus Black Edition:
Table of Contents

Advertisement

Lithium Battery Program
Lithium:
This program is only suitable for charging/discharging Lithium chemistry
batteries (LiPo, LiHV, LiIon and LiFe).
The X2 AC Plus Black Edition offers the following lithium charge modes: Charge,
Balance Charge, Fast Charge, Storage and Discharge.
BEFORE SELECTING A CHARGE MODE, IT IS CRITICAL THAT YOU SELECT THE
CORRECT TYPE OF LITHIUM BATTERY TO BE CHARGED. FAILURE TO DO SO
Warning
CAN RESULT IN DAMAGE TO THE BATTERY AND POSSIBLE EXPLOSION.
Selecting a Lithium Battery Type:
BATT/PROGRAM
LiPo BATT
Once you have selected the correct battery type, press the ENTER/Start ►
button to enter the charge/discharge menu.
Lithium Charge Mode:
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
Warning
INFORMATION CONTAINED ON PAGES 02-07.
IN THE CHARGE MODE, LITHIUM BATTERIES CAN BE CHARGED WITHOUT
THE USE OF A BALANCE ADAPTOR. A BALANCE ADAPTOR CAN BE USED,
Note
BUT IT IS NOT REQUIRED. BALANCE CHARGE MODE IS RECOMMENDED
FOR ANY BATTERY WITH A BALANCE LEAD.
See page 12 for the Appropriate charging connections setup for this operation.
First, select the correct battery type by following the instructions page 16.
Once you have set the correct battery type, press the ► button once to enter
the charge mode and battery settings screen, use the INC. – or DEC + to select
"CHARGE" mode. Press the ► button again and the amp rate value will begin
flashing. Use the + or ▬ buttons to adjust the value to the desired rate. Follow
the instructions provided with your battery when setting the charge amperage
rate.
LiPo Charge
2.7A
11.1V (3S)
desired rate. The voltage and cell count should match the values listed on the
battery label.
[LiPo/LiHV/LiFe/Lilon]
From the "BATT/PROGRAM" screen, press the INC. – or
DEC + button to scroll through the battery type selections.
Press the ► button again and the voltage value will begin
flashing. Use the + or ▬ buttons to adjust the value to the
19

Advertisement

Table of Contents
loading

Table of Contents