Dc Power Supply - HITEC X2 AC Plus Black Edition Manual

DC Power Supply

To use the X2 AC Plus Black Edition as a power supply, the user must connect the
charger to an AC power source. When the green LED on the back side turns on, the
user is free to use the power supply. The power of the DC output is adjustable from
10W to 100W and the output voltage is 13.8V. The power of DC output is shared with
charger power. When you increase the power of DC output, the charger power will be
decreased accordingly.
(DC Power + Channel A + Channel B = 100 Watts).
Operating Instruction
BATT/PROGRAM
SYSTEM SETTING->
DC SUPPLY: 20W
CHA: 50 CHB: 30W
CH1: 50 CH2: 50W
DC SUPPLY: 150W
Caution: The maximum DC Power output is 100 Watts. Please check the total
loading of your equipment before using DC power supply.
If the DC power supply is over load, the led light will flash red and stop working.
34
Press ENTER to enter the DC Power Supply program
Set the output power for the DC charger or other devices.
(please note the voltage is 13.8V)
Set the power of channel A and channel B and the power
supply will take the rest power automatically.
EXPLANATION OF LED STATUS
OFF DC Power Off
Green 0-30% Loading
Yellow 31-60% Loading
Red 61-100% Loading
Red Blinking Over Load