Program Blocks - Miele PG 8581 Operating Instructions Manual

Program blocks

The wash block sequence is pre-determined and is the same as the
sequence in the program chart (see "program chart").
– Pre-rinse 1 to 3
Pre-washing removes coarse soiling and foam-building substances.
– Main wash 1 and 2
Depending on the wash load, cleaning generally occurs at
temperatures between 113°F/45°C and 149°F/65°C with the
addition of an appropriate process chemical.
Interim rinse 1 4
– to
In the interim rinse stages, the chemical agents from the
previous wash blocks are rinsed off and neutralized where
necessary by the addition of appropriate neutralizing agents.
Final rinse 1 2
– and
To avoid deposits and corrosion on the wash load, demineralized
(DI) water should preferably be used if available for the final rinse.
According to the A
thermally at temperatures of 176°F to 203°F/80°C to 95°C and with
relevant holding times.
Drying
–
Adequate drying reduces the risk of corrosion by residual moisture
on the load.
Program block parameters are accessible only to Miele Technical
Service, with the exception of the dispensing of rinse aid and
drying parameters.
concept of EN ISO 15883, disinfection occurs
0
Program settings
85