Table of Contents
Advertisement
CHAPTER 3: INSTALLING ASHBY LOUDSPEAKERS
8. Place the speaker grille on the installed speaker.
Make sure to line up the grille with the magnets on the
speaker.
Figure 18: Placing the speaker grille on the speaker
INSTALLING INTO A SUSPENDED CEILING
1. Assemble the C-ring with tile bridge in the ceiling.
2. Slide the C-ring on the tile bridge until it is centered with
the hole.
Clamps
Figure 19: Installing the speaker into the C-ring with Bridge Kit
3. Install washers and #6 sheet metal screws (included) into
the C-ring and tighten into place.
4. Install the speaker by tightening the screws on the bezel
of the speaker to clamp it to the C-ring (see Figure 16 on
page 15 to locate the clamping screws).
NOTE:
The tile bridge acts as a fail-safe in case
the tile gets damaged, so it may not contact the
railings.
16
Screws
Figure 20: Installing the speaker into a bridge in the ceiling
Safety Lanyard
Some construction codes require a secondary support system.
Ashby speakers have a built-in attachment point for a load-
rated carabiner with lanyard (neither included) to safely sup-
port the weight of the speaker.
Figure 21: Attaching a safety lanyard for secondary support
Advertisement
Table of Contents
