Table of Contents
Advertisement
INSTALLING INTO A HIGH CEILING WITH THE
PENDANT
The pendant is designed to replicate flush-mounted ceiling
installations, utilizing the four integrated clamps, and thus do
not require extra hardware.
To install the speaker in a pendant:
1. Remove the speaker grille and make sure that the clamps
are away from the front of the bezel and locked in the
open position.
2. Attach the supplied lanyard using the supplied hardware
onto the speaker to act as a secondary support.
Figure 22: Attaching a safety lanyard
3. Insert wires through the grommets and attach them to the
Ashby connector panel.
See Appendix D, "Ashby Pendant Dimensions" to see
where these items are located.
4. Slide the lanyard through one of the holes.
5. Insert the Ashby loudspeaker inside the pendant and
rotate the four Phillips head screws clockwise to engage
the speaker clamps to the pendant.
Figure 23: Installing an Ashby speaker into a Meyer Sound pendant
6. Lock the speaker securely into place by tightening the
mounts until the speaker is flat against the pendant.
CAUTION:
Do not over tighten! If using a pow-
ered screwdriver, set the torque to 0.8 N-m (7 in-
lbs). if the screwdriver torques out, slowly increment
the torque setting until the mounting clamps begin to
move.
7. Attach the lanyard to a secondary support point.
8. Before placing the grille frame, choose an attenuation set-
ting, if the speaker has this feature (see Figure 17).
9. Place the speaker grille on the installed speaker.
Make sure to line up the grille with the magnets on the
speaker.
Figure 24: Fitting the grille frame onto an Ashby speaker in a pendant
ASHBY OPERATING INSTRUCTIONS
17
Advertisement
Table of Contents
