Installing Into A Suspended Ceiling - Meyer Sound Ashby-5C Operating Instructions Manual

CHAPTER 3: INSTALLING ASHBY LOUDSPEAKERS
8. Place the loudspeaker grille on the installed loudspeaker.
Make sure to line up the grille with the magnets on the
loudspeaker.
Figure 18: Placing the loudspeaker grille on the loudspeaker

INSTALLING INTO A SUSPENDED CEILING

1. Assemble the C-ring with tile bridge in the ceiling.
2. Slide the C-ring on the tile bridge until it is centered with
the hole.
Clamps
Figure 19: Installing the loudspeaker into the C-ring with Bridge Kit
3. Install washers and #6 sheet metal screws (included) into
the C-ring and tighten into place.
4. Install the loudspeaker by tightening the screws on the
bezel of the loudspeaker to clamp it to the C-ring (see
Figure 16 on page 19 to locate the clamping screws).
NOTE: The tile bridge acts as a fail-safe in case
the tile gets damaged, so it may not contact the
railings.
20
Screws
Figure 20: Installing the loudspeaker into a bridge in the ceiling
Safety Lanyard
Some construction codes require a secondary support system.
Ashby loudspeakers have a built-in attachment point for a
load-rated carabiner with lanyard (neither included) to safely
support the weight of the loudspeaker.
Figure 21: Attaching a safety lanyard for secondary support