Huawei Quidway S9300 Configuration Manual page 251

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3.
4.
5.
Issue 01 (2009-07-28)
Destination/Mask Proto
1.1.1.9/32 Direct 0
InLoopBack0
2.2.2.9/32 OSPF
3.3.3.9/32 OSPF
4.4.4.9/32 OSPF
OSPF
100.1.2.0/24 Direct 0
100.1.2.1/32 Direct 0
InLoopBack0
100.1.2.2/32 Direct 0
100.1.3.0/24 Direct 0
100.1.3.1/32 Direct 0
InLoopBack0
100.1.3.2/32 Direct 0
100.2.3.0/24 OSPF
OSPF
100.2.4.0/24 OSPF
100.3.4.0/24 OSPF
127.0.0.0/8 Direct 0
InLoopBack0
127.0.0.1/32 Direct 0
InLoopBack0
127.255.255.255/32 Direct 0
InLoopBack0
255.255.255.255/32 Direct 0
InLoopBack0
Set up LSPs on the MPLS backbone network.
Enable MPLS and MPLS LDP on the devices and interfaces along the LSP. The
configuration procedure is not given here.
After the configuration, run the display mpls ldp session command, and you can see in
the display that the Session State item is Operational.
Take the display on PE1 and P1 for example.
[PE1] display mpls ldp session
LDP Session(s) in Public Network
----------------------------------------------------------------------
Peer-ID Status
----------------------------------------------------------------------
2.2.2.9:0 Operational DU
3.3.3.9:0 Operational DU
----------------------------------------------------------------------
TOTAL: 2 session(s) Found.
LAM : Label Advertisement Mode
[P1] display mpls ldp session
LDP Session(s) in Public Network
----------------------------------------------------------------------
Peer-ID Status
----------------------------------------------------------------------
1.1.1.9:0 Operational DU
3.3.3.9:0 Operational DU
4.4.4.9:0 Operational DU
----------------------------------------------------------------------
TOTAL: 3 session(s) Found.
LAM : Label Advertisement Mode
Configure a VPN instance on PE.
For the configuration procedure, see
VPN. The configuration details are not mentioned here.
Set up EBGP peer relation between the PE and the CE and import VPN routes.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Pre Cost Flags
0
10 2
10 2
10 3
10 3
0
0
0
0
0
0
10 2
10 2
10 2
10 2
0
0
0
0
LAM SsnRole SsnAge
Passive 000:00:01
Passive 000:00:00
SsnAge Unit : DDD:HH:MM
LAM SsnRole SsnAge
Active 000:00:02
Passive 000:00:01
Passive 000:00:00
SsnAge Unit : DDD:HH:MM
Example for Configuring the BGP/MPLS IP
3 BGP/MPLS IP VPN Configuration
NextHop
D 127.0.0.1
D 100.1.2.2
D 100.1.3.2
D 100.1.3.2
D 100.1.2.2
D 100.1.2.1
D 127.0.0.1
D 100.1.2.2
D 100.1.3.1
D 127.0.0.1
D 100.1.3.2
D 100.1.3.2
D 100.1.2.2
D 100.1.2.2
D 100.1.3.2
D 127.0.0.1
D 127.0.0.1
D 127.0.0.1
D 127.0.0.1
KA-Sent/Rcv
8/8
4/4
KA-Sent/Rcv
11/11
8/8
4/4
Interface
Vlanif10
Vlanif40
Vlanif10
Vlanif40
Vlanif10
Vlanif10
Vlanif40
Vlanif40
Vlanif40
Vlanif10
Vlanif10
Vlanif40
3-149