Enabling The Vpn Binding Feature For The Tunnel - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
l
l
In addition, you can configure an MPLS TE tunnel on the PEs of the backbone network and
configure the MPLS L2VPN binding.
Pre-configuration Tasks
Before configuring the MPLS L2VPN tunnel binding, complete the following tasks:
l
l
l
l
l
l
Data Preparation
To configure the MPLS L2VPN tunnel binding, you need the following data.
No.
1
2
3

1.7.2 Enabling the VPN Binding Feature for the Tunnel

Context
Do as follows on the PEs configured with VCs.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface tunnel interface-number
Issue 01 (2009-07-28)
Use an MPLS TE tunnel to transmit user data, which optimizes the use of network resources
and avoids network congestion caused by unbalanced load.
Ensure that L2VPN services are independent of other services and are not affected by other
services. This guarantees the QoS.
Connecting interfaces and setting the physical parameters of each interface to make the
physical layer in Up state
Setting the parameters of the link layer protocol and the IP address of the interface to enable
the link layer protocol.
Configuring the static routes or an IGP protocol to ensure that the nodes are routable
Configuring basic MPLS functions and enabling MPLS TE
Configuring the MPLS TE tunnels between PEs (For details, refer to the Quidway
S9300Terabit Routing Switch Configuration Guide - MPLS)
Creating the VC on the PE (For details, refer to
Data
Name of a tunnel policy
QoS parameters applied to the TE tunnel (such as bandwidth)
Types and numbers of VC interfaces to which a tunnel policy is applied, destination
addresses, and VC IDs
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 VPN Tunnel Management
VLL Configuration.
1-21