Configuration Guide; Configuration Via Web Browser; Accessing The Web Ui Using Upnp Feature; Accessing The Web Ui Using Dp750 Repeater Management Mode - Grandstream Networks DP760 User Manual

CONFIGURATION GUIDE

The DP760 can be configured via the Web GUI embedded using PC's web browser. By default, DP760 is
configured to obtain IP address from DHCP server where the unit is located and can be also discovered
using UPnP feature (by default enabled).

Configuration via Web Browser

The DP760 embedded Web server responds to HTTP/HTTPS GET/POST requests. Embedded HTML
pages allow a user to configure the DP760 through a Web browser such as Google Chrome, Mozilla Firefox
and Microsoft's IE.
Note: If DP760's IP is known; users can access to its web interface by entering the IP address in their web
browser from a computer connected to same network.

Accessing the Web UI using UPnP Feature

DP760 supports UPnP feature (by default enabled) for auto discovery by computers in same network.
Please refer to following steps in order to access DP760 Web UI:
1. Power on DP760 and connect it to the network.
2. Connect a computer to same network as DP760. (The computer must be connected to the same
sub-network as the DP760. This can be easily done by connecting the computer to the same hub
or switch as the DP760).
3. Access "Network" directory on the computer.
4. Locate "GRANDSTREAM-DECTREPEATER" device and double click on it to access web GUI.
5. Enter admin's username and password and press Login button to access the configuration menu.
(Default username and password are: admin/admin)

Accessing the Web UI using DP750 Repeater Management Mode

The repeater management mode on the DP750 allows managing discovered / paired repeater stations and
also accessing the DP760 Web UI from DP750 web GUI. Please refer to following steps in order to access
DP760 Web UI using DP750 repeater management mode:
1. Access DP750 Web GUI. (Default username and password are: admin/admin).
2. Navigate to DECT -> General Settings and set Enable Repeater Management to "Yes".
3. Press Save and Apply button, then reboot the unit to apply the new settings.
4. After finishing the reboot, access again the DP750 Web GUI.
5. Navigate to Status -> DECT Repeater Status.
6. Access the discovered or paired repeater web UI by clicking on its IP address.
7. You will be redirected to login page of the repeater, enter admin's username and password and
press Login button to access the configuration menu. (Default username and password are:
admin/admin)
DP760 User Manual
P a g e | 17