Programming; A.1 Programming - Aaeon PFM-620S Manual

P C / 1 0 4 C P U M o d u l e

A.1 Programming

An onboard watchdog timer reduces the chance of disruptions
which CPLD (Compact Programmable Logical Device) interface
can cause. This is an invaluable protective device for standalone
or punmanned applications. When the watchdog timer activates
(CPU processing has come to a halt), it can reset the system, or
generate an interrupt on IRQ10, IRQ11, IRQ15, and NM1. This
can be set via I/O Port 444, the function as following:
0: RESET
1: NM1
2: IRQ10
3: IRQ11
4: IRQ15
If you decide to program the watchdog timer, you must write data
to I/O port 443 (hex). The output data is a value timer. You can
write form 01 (hex) to FF (hex) while simultaneously setting it.
When you want to disable the watchdog timer, your program
should read a Hex value from I/O port 80 (hex).
The following procesude is a sample program for the watchdog
timer:
The time interval data of the watchdog timer is shown in binary
code (8 bits). Sample 2: 5 seconds
Appendix A Programming the Watchdog Timer
Type C:\DOS\Debug <ENTER>
To start watchdog timer and set function "Reset" type;
o 444 0<Enter>; out 444h data 0
To input Watchdog timers time-out interval of 5
seconds type; o 443 05<Enter>; out 443h data 05
To disable the watch timer type; i80 <Enter>
0 0 0 0
A-2
P F M - 6 2 0 S R e v . B
0 1 0 1