13
Looper thread puller
.06.34
Rule
When the needle bar is at t.d.c., Needle bar (adjustment hole 1) both looper thread puller
eyes 1 should stand on the front edge of the thread controller 4.
Fig. 13 - 34
Move the needle bar to t.d.c.
Twist the looper thread puller 1 (screw 2) according to rule 1, in doing so ensure that the
yoke of the looper thread puller 1 stands centrally to the thread regulator 3.
3
5
4
1
1
2
A deviation from the home position may be necessary depending on the
material being sewn and the type of thread.
4
1
3
Adjustment
2
103