Table of Contents
Advertisement
Boot Type: Select boot type to Dual type, Legacy type or UEFI type.
Quick Boot: Allows InsydeH20 to skip certain tests while booting. This will decrease
the time needed to boot the system.
Quiet Boot: Disables or enables booting in Text Mode.
Network Stack: Network Stack Support - Windows 8 BitLocker unlock.
PXE Boot capability: Disabled = Support network stack.
Power Up In Standby Support: Disable or enable Power Up In Standby Support. The
Add Boot Options: Position in Boot order for shell, Network and Removables.
ACPI Selection: Select booting to ACPI 3.0 / ACPI 1.0B.
USB Boot: Disables or enables booting to USB boot devices.
EFI/Legacy Device Order: Determine EFI device first or legacy device first. Legacy First,
Timeout: The number of seconds that the firmware will wait before booting the
original default boot selection. Range 0 ~ 10.
Automatic Failover: Enable = if boot to default device fail, it will directly try to boot
Logo Resolution: Change Logo Resolution.
EFI: EFI Boot Order Setting.
Legacy: Legacy Boot Order Setting. Reference the 3.7.5.1 section.
Boot Configuration: Configures Boot Setting. Reference the 3.7.5.2 section.
Function Item
Boot Type
Quick Boot
Quiet Boot
UEFI PXE = IPv4/IPv6.
Legacy = Legacy PXE OPROM only.
PUIS feature set allows devices to be powered-up into
the standby power management state to minimize
inrush current at power-up and to allow the host to
sequence the spin-up of devices.
EFI First or Smart Mode.
next device.
Disable = if boot default device fail, it will pop warning message
then go into firmware UI.
(Cannot
setting)
UEFI IPv4/IPv6 PXE legacy PXE.
Legacy PXE OPROM.
Select Item_1
Dual Boot Type
(Default
Legacy Boot Type
UEFI Boot Type
Enabled
(Default
setting)
Disabled
Enabled
(Default
setting)
63
setting)
Advertisement
Table of Contents
