Cobalt Digital Inc 9083 Product Manual page 40

2
2-4
Repeat steps 1 through 8 for other 9083 cards.
9.
Note: The 9083 BNC inputs are internally 75-ohm terminated. It is not necessary to
terminate unused BNC inputs or outputs.
Note: External frame sync reference signals are received by the card over a refer-
ence bus on the card frame, and not on any card rear I/O module connectors.
The frame has BNC connectors labeled REF 1 and REF 2 which receive the
reference signal from an external source such as a house distribution.
Note: To remove a card, press down on the ejector tab to unseat the card from the
rear I/O module mating connector. Evenly draw the card from its slot.
If network remote control is to be used for the frame and the frame has
10.
not yet been set up for remote control, perform setup in accordance with
®
Cobalt reference guide "COMPASS™ Remote Control User Guide (PN
9000RCS-RM)".
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
9083 (WITH DOLBY ENCODING OPTION) PRODUCT MANUAL
Installing the 9083 Into a Frame Slot
9083-ENC-OM (V4.4)