Release Handle Clamp - Max Megatron 1400HP Quick Install Manual

3

release handle clamp

IMPORTANT: Handle MUST be
HORIZONTAL when FIRMLY in
secure position.
YES YES
NO
Adjustment:
IMPORTANT: Tighten the adjustment bolt until
NO SLIPPAGE
occurs when handle is in the
SECURE HORIZONTAL position.
Test for Arm Slippage: When Release Handle Clamp is
in the SECURE HORIZONTAL position, Pull the end of
gate. NO slippage should occur. If it does, re-adjust bolt.
Re-Attach Arm to Operator:
Limit pin MUST fit into slot in
bottom of release handle clamp
directly under the arm when
re-attaching arm to operator.
Arm
Slot
Limit Pin
Limit Rings
3
Handle in release position
factory set bolt
DO NOT adjust
Adjustment
Bolt
IMPORTANT: The arm MUST NOT slip when
the gate is cycling or the gate OPEN and
CLOSE limit positions will NOT be LEARNED.
Gate speed will remain slow if gate positions
are NOT learned.
NOTE: Limit rings that have been previously
set will automatically re-align the gate's open
and close position after release handle clamp
has been re-attached and secured.
No re-adjustment is necessary.
UL 325 2016 Standard-Megatron Quick Install Rev 10
ERD MC-200
Motor Sensitivity JOG JOG Motor Controller
OverLoad LEFT RIGHT MATRIX ON-LINE Edge UL Entrap
5 4 3 1 POWER
MAX 2
ERD 12 16 LED ON Limit SW Edge PhotoCell
13 14 15
POWER/SOLAR POWER
IN IN
TO MOTOR
CONTROLLER
BATTERY BATTERY
MA TRIX 1 BACK-UP CLOSED LEAVE BA TTERY IN MODE PRIMARY GA TE MAGLOCK PACK
MADE in USA AUTOMA TIC LEAVE OPEN OPEN/CLOSE OPEN 1 TIME LEFT OPEN CONTROLS RIGHT OPEN OFF DELA Y 1.5Sec 2Sec MAG LOCK COM NC
EXIT T AILGA TE ON ANTI OFF EXIT CENTER SAFETY T AMPER GA TE T amper T amper COM IN GND NO
SAFETY CENTER MIN OFF MAX UL PHOTOCELL EDGE 1
ID PLUG CLOSE TIMER PARTIAL OPEN MOTOR MOTION ENTRAP EDGE ID ERROR PLUG 2
GND 12VDC RECORDER POSITION OBD PORT MAX GA TE OPEN SPEED STOP REVERSE SENSITIVITY MOTOR OVERLOAD CLOSE UL ALARM ALARM RESET 12V RET GND
GND 24VDC BLACK BOX MIN MAX SWITCH LIMIT NO LIMIT SWITCH / CLAMP SLIPPING ST A TUS GA TE BA TTERY CLOSE OPEN COM
PRIMARY GA TE MOTOR ON-LINE ON-LINE GA TE SEC IN POWER USE
www.max.us.com
Made in USA