Table Of Contents - Max Megatron 1400HP Quick Install Manual

Quick Install Guide
1. Operator Placement
2. Arm Position
3. Release Handle Clamp
4. AC Input Power
5. Ground Operator
6. Set Opening Direction and ID Plug
7. Limit Switch Adjustment
8. Entrapment Protection Wiring
9. Learn Gate Positions
10. Adjust ERD Reverse Sensor
11. Loops & Loop Detectors
12. Matrix 1 Settings
13. Wiring Opening Device Options
Dual Gate Operators Wiring
Megatron specifications
UL 325 Class of Operation
Gate Type - Vehicular Swing Gate
Input AC Power/Amps - Switchable: 115VAC / 6 Amp, 1 phase
or 230VAC / 2 Amp, 1 phase
Motor - 24VDC Brushless (equivalent to 1 HP AC motor)
Operating Temperature: -4°F to 158°F (-20°C to 70°C)
Cycles per Hour AC Input Power
Battery Back-Up Cycles (BC-7 Battery Module-7 Amp/Hr
Batteries fully charged): - Approximately 450 cycles
NOTE: The number of gate cycles using ONLY battery back-up power will vary depending on the
weight of the gate, the gate length, the operating condition of the gate hardware, temperature and
the amount of charge the batteries have at the beginning of the battery power only operation.
Max Gate Weight / Length:
- MAX Megatron 1400 and 1400HP - 1400lbs @ 15 ft or 1200 lbs @ 20 ft
- MAX Megatron 2200 and 2200HP - 2200lbs @ 15 ft or 1500 lbs @ 20 ft
- MAX Megatron 2200 PLUS and 2200HP PLUS - 2500lbs @ 15 ft or 1800 lbs @ 20 ft
- MAX Megatron FAST - 1200lbs @ 12 ft gate per operator
- MAX Megatron FAST PLUS - 1600lbs @ 12 ft gate per operator
NOTE: The MAX Megatron FAST and FAST PLUS are ONLY available for installation on bi-parting gates
(dual operators). A single gate operator CANNOT be used.
90° Opening Time:
- MAX Megatron 1400/1400HP/2200/2200HP/2200 PLUS/2200HP PLUS - 16 selectable speeds
from approximately 11.5 sec to 20 sec depending on the weight and length of the gate.
- MAX Megatron FAST and FAST PLUS - 16 selectable speeds from approximately
6 sec to 14 sec depending on the weight and length of the dual gates.
Entrapment Protection:
- UL 325 Type A Inherent (ERD sensor)
- Inputs for NORMALLY CLOSED (N.C.) UL 325
Type B1 (photo cell) and Type B2 (sensing edge)

Table of Contents

- Class I, II, III, IV
- Continuous
Troubleshooting
USB Black Box Port
1
Test Edge 1 Entrapment sensor
2
Gate Cycling Troubleshooting
3
Matrix 1 LED Troubleshooting
4
MC-200 LED Troubleshooting
5
BC-7 Module LED Troubleshooting
5
6
Commonly Used Safety Sensor Wiring
7-8
8
9
9
10
10
11
25.2"
High Profile
2200HP PLUS
17"
2200 Plus
FAST PLUS
2
26.6"
1400HP
2200HP
1400
2200
18.5"
FAST
UL 325 2016 Standard-Megatron Quick Install Rev 10
12
12
13
14-15
16
17
18-21
29.9"
24.5"
16.8"
24.5"
18.3"
21.3"