Support Bracket; Bottom Shelf - Rinnai Coastal Customer's Operating And Assembly Instructions

7
Support
bracket
3. Screw the four (4) castors into the castor mounting
blocks in the bottom of each trolley leg. Turn the
threaded castor stem by hand, clockwise until it
stops. Fully tighten with the spanner provided.
Refer to diagram 2.
4. Attach the four (4) side shelf brackets to the tops of
the trolley legs using eight (8) of the
Phillips-head screws. Be sure the flat side of each
bracket faces outward. Secure firmly.
Refer to diagram 2.
Orifice

support bracket

5. Place the side shelves over the brackets and cross
braces with the wider-spaced shelf holes to the
outside (shelf with panel on right side). Be sure the
inside shelf holes align with the support bracket
holes. Refer to diagram 3.
A S S E
Diagram 1.
Bottom
shelf
1 1
/ " x / "
4 2
Diagram 2.
Shelf bracket, flat
side facing outward
M B L Y
Cylinder
hook
Cylinder
gas support
6. To connect the side shelf handle, remove the bolt
and washer from one side of the handle (cap
remains with handle).
washer onto bolt and insert bolt through end of
shelf bracket, side shelf, and into handle. Leave
bolt loose until other side of handle is attached,
then fully tighten both sides. Repeat for side burner
shelf.
Install the match lighting stick and chain on the
right rear leg using M4 x 10 mm self-tapping
Phillips-head screw. Refer to diagram 3.
Diagram 3.
Side burner
frame
Side burner
lid
Side
shelf
Align
holes
Match lighting
stick and chain
From beneath shelf, place
7