Door Bracket; Door; Door Handle; Shelf Bracket - Rinnai Coastal Customer's Operating And Assembly Instructions

10
7. Attach the door bracket to the lower holes in the
front legs with the end tabs pointing upward and
the flange to the rear, pointing downward. Use
1
two (2) of the / " x
4
not fully tighten. Refer to diagram 4.
8. Place doors into the hinge holes of the bottom shelf
and door bracket. Push door bracket down until
doors are secure and can open and close freely. Do
not fully tighten door bracket screws.
Refer to diagram 4.
9. Remove protective film from doors. Install door
handles to doors using four (4) of the
Phillips-head screws and washers. Refer to diagram 4.
Lower
hole
Screw with
washer
Remove

Door

film
Handle
Hinge
10. Attach the four (4) side shelf brackets to the tops of
the trolley legs using eight (8)
head screws. Be sure the flat side of each bracket
faces outward to the front and rear. Fully tighten.
Refer to diagram 5.
Orifice
support
bracket
A S S
1
/ " Phillips-head screws. Do
2
3
/ " x
16
Diagram 4.
Door
bracket
Hinge hole
1 1
/ " x / " Phillips-
4 2
Diagram 5.

Shelf bracket,

flat side facing
outward
E M B L
11. Place the side shelves over the brackets and cross
braces with the wider-spaced shelf holes to the
outside (shelf with panel on right side). Be sure the
inside shelf holes align with the support bracket
Refer to diagram 6.
12. To install the side shelf handle, remove the bolt
and washer from one side of the handle (cap remains
with handle). From beneath shelf, place washer onto
bolt and insert bolt through end of shelf bracket,
side shelf, and into handle. Leave bolt loose until
other side of handle is attached, then fully tighten
both sides. Repeat for side burner shelf.
3
/ "
8
Install the match lighting stick and chain on the
right rear leg using M4 x 10 mm self-tapping
Phillips-head screw. Refer to diagram 6.
Y
Side burner
frame
Side burner
lid
Align
holes
Match lighting
stick and chain
10
Diagram 6.
Side
shelf