Start And Stop Procedures And Basic Operation; Start And Stop Procedures - Omron BU150R Instruction Manual

3-3

Start and stop procedures and basic operation

3-3-1 Start and stop procedures

For cautions when operating the UPS, including start and stop, refer to "Caution (for use)"
shown in the "Safety precautions" of the beginning of this manual.
■Start procedure
Turn on the "Power" switch of the UPS.
・Output begins in Bypass Operation a few seconds after the switch is activated. (Status
indicator "
・The status indicator displays "
Mode for about 15 seconds. If the battery voltage is low, the self-diagnostic test is not
performed. It is automatically executed after the battery is charged (approximately 8
hours). When the self-diagnostic test finishes successfully, switching to AC output from
commercial power is performed and normal operation starts.
・When the self-diagnosis test finishes normally, the unit enters the normal operating state
through inverter operation.
・When the self-diagnostic test is not performed, AC output begins immediately inverter
operation.
Status indicator
・During operation, the battery is charged automatically.
AC input
7 seg.
Power supply SW
Power supply
output lamp
Commercial
Operating mode
Power Battery
Commercial
Output
Power Battery
BU150R
3-3 Start and stop procedures and basic operation
")
", and the self-diagnostic test is performed in Battery
Beep
None
ON
OFF
D-1
ON
OFF
ON
OFF
Startup
preparation
seconds
1 sec.
<Note>
D-1: Display the latest UPS fault mode
(If there is no record for UPS fault, UPS display the
3 Check and start operation
Power supply output receptacles
Outputs power (connected devices are
powered)
Bypass Self-diagnostic
operation
a few a few
seconds
Inverter
operation
test
about
15 sec.
3
43