Flashing Leds-9100 Series- (Diagnostic Indicators) - Norcold 9182 Service Manual & Parts List

Description of 9100 Series Flashing LED's (Diagnostic Indicators)
The LEDs on the front display panel flash if a fault occurs within the operating controls. The flashing LEDs assist the service
technician in trouble shooting and alert the refrigerator owner to a problem in any mode of operation. When a problem occurs
within a given mode, the operating controls revert to a stand-by mode in which an LED or series of LEDs begin flashing. The
LED or LEDs continue flashing until either the control is turned Off and then back On or the problem is corrected. Flashing
LED's and their meanings begin below.
Flashing LP Gas LED-All Models
Flashing AC LED-All Models
Flashing AC LED-All Models
Flashing Battery LED-All Models
All LED's Flashing-3 Way Models Only
All LED's Flashing-All Models
All LED's Flashing-3 Way Models Only
(LED will flash, pause, flash, pause, etc.)
Burner ignition failure on initial start-up or gas re-ignition during a cycle period.
(LED will flash, pause, flash, pause, etc.)
Fault external to refrigerator controls. AC mode selected, AC power not available.
(LED will flash, flash, pause, flash, flash, pause, etc.)
Fault external to refrigerator controls. AC input voltage either too high or too low.
(LED will flash, flash, pause, flash, flash, pause, etc.)
Fault external to refrigerator controls. DC input voltage either too high or too low.
All LED's will flash, pause, flash, pause, etc.)
In the AUTO mode, the burner failed ignition and DC heater failed.
(The LED will flash, pause, flash, pause, etc.)
AC heater output fault. The control senses AC heater current when the AC heater
(The LED's will flash, pause, flash, pause, etc.)
DC heater output fault. The control senses DC heater current when the DC heater
11
should be OFF.
should be OFF.