Table of Contents
Advertisement
3.
If you are requested to enter a password, enter the password using the number keys,
and then press the [OK] key.
4.
Press the [ ] or [ ] key to select [Wi-Fi], and then press the [OK] key.
5.
Press the [ ] or [ ] key to select [Setup Wizard], and then press the [OK] key.
6.
Select [Infrastructure], and then press [Next].
7.
Press the [ ] or [ ] key to select the destination SSID, and then press [Next].
If you cannot find the destination SSID, check if the device is turned on.
When entering the SSID, select [Input SSID], and then press [Next].
The SSID entry screen appears. Enter the SSID using the number keys, and then press [Next].
8.
Press the [ ] or [ ] key to select the authentication method, and then press [Next].
Select the same method that the router or access point is using.
If you have selected [WPA2-PSK] or [Mix Mode WPA2/WPA], proceed to Step 10.
9.
Press the [ ] or [ ] key to select the encryption method, and then press [Next].
Select the same method that the router or access point is using.
10.
Enter the encryption key using the number keys, and then press [Connect].
If you selected [Shared Key] or [Open System] in Step 8, it is necessary to enter the ID. The ID is
used for identifying the encryption key. You can register four encryption keys (ID 1 to 4). Use the
[ ] or [ ] key to switch between the encryption key and ID settings.
11.
Press [Yes].
After connecting to the network, the Wi-Fi screen is displayed.
12.
Press the [ ] or [ ] key to select [Wi-Fi Status], and then press the [OK] key.
When "Connected" is displayed, the connection has been established.
When "Disconnected" is displayed, the connection has not been established. Start again from the
beginning.
Ad Hoc mode
This section explains how to connect directly to devices equipped with a wireless LAN, such as
computers on a peer-to-peer network.
• Make sure [Wi-Fi/LAN Key] is set to [Ad-Hoc Mode]. For [Wi-Fi/LAN Key], see page 155
"Network Settings".
• In Ad Hoc network, every device must be manually assigned an IP address for TCP/IP if there is no
DHCP server.
• In Ad Hoc mode, only Open System or WEP encryption is supported. WPA2-PSK and Mix Mode
WPA2/WPA authentication methods are not supported.
opal-p2_mf2_com_user_guide_00142080_eng.xml
Configuring Network Settings
Draft 2014/01/07
33
Advertisement
Table of Contents
