HP ProLiant DL360 Gen10 User Manual page 55

For more information, contact a Hewlett Packard Enterprise authorized reseller.
Procedure
1. Back up all server data.
2. Power down the server (Power down the server on page 24).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 24).
b. Remove the server from the rack (Remove the server from the rack on page 25).
5. Remove the access panel (Remove the access panel on page 25).
6. Remove the universal media bay blank.
7. Install the 2 SFF NVMe drive cage.
8. Remove the primary PCI riser cage (Removing the primary PCI riser cage on page 27).
9. Remove the existing riser board.
Hardware options installation 55