Scanning; Scanning Information - Viessmann VITODENS Series Operating Instructions Manual

Scanning

Scanning information

Subject to the connected components
and settings made, you can scan current
temperatures and operating conditions.
Press the following keys:
1. for settings; "
2. for " ".
3. OK to confirm.
4. / for the required information.
5. OK to confirm; if you want to reset
the value to "0" (see following
table), " " flashes.
The information appears in the following sequence:
Display
0 10
1 15 °C Outside temperature
2 95 °C Flue gas temperature
3 65 °C Boiler water temperature –
4 45 °C Temperature, heating
5 50 °C DHW temperature
51 50 °C DHW temperature, top
52 50 °C DHW temperature, bot-
5c 95 °C Collector temperature
5□ 45 °C DHW temperature with
22
" flashes.
Meaning
LON subscriber number
water buffer cylinder or
low loss header
tom
solar operation
6. OK to confirm; the value is reset.
Example:
On the display, you can see the number
"3" which indicates the heating flow tem-
perature. The current heating flow tem-
perature is 65 °C.
¸
3
Note
The scan mode terminates automatically
after 30 min or if you press
Notes
–
Display only if an outside tempera-
ture sensor is connected.
–
Displayed only if a heating water
buffer cylinder or low loss header is
connected.
Displayed only if a DHW cylinder is
connected.
Displayed only if two cylinder tem-
perature sensors are connected.
Displayed only if a Viessmann solar
control module is installed.
Displayed only if a solar thermal
system is connected.
°C
6 5
.