Connecting To A Hob - NEFF I38KHV2S0 Instructions For Installation And Use Manual

eConnecting to a hob
You can connect this appliance to a hob and then
h o b C o n n e c t i n g t o a
control the functions of the hood via your hob.
Appliances can be connected to each other in different
ways:
Connecting appliances directly
If the appliance is connected directly to a hob, it cannot
be connected to your home network as well. The
appliance works like an extractor hood that is not
connected to the network and you can continue to
operate it via the control panel.
Connecting appliances via your home network
You can connect the appliance to the hob via your
home network and make use of the existing
infrastructure.
Notes
Make sure you follow the safety instructions in the
■
instruction manual for your extractor hood and that
these are complied with even when operating the
appliance via the hood controls on the hob.
Using the controls on the extractor hood always take
■
priority. It is not possible to use the hood controls on
the hob during this time.
Setting up a connection
The hood must be switched on before you can connect
the hob and extractor hood.
Make sure that the hob is switched on and is in search
mode.
Refer to your hob's instruction manual for more
information.
Connecting directly
Press and hold the and
#
until the and indicators start flashing.
D Ù
The extractor hood has been connected to the hob
when the stops flashing and remains continuously
D
lit.
Connecting via your home network
Notes
You require a router that has WPS functionality.
■
You require access to your router.
■
The extractor hood cannot be switched on during the
■
connection process. You can cancel the process at
any time by pressing the
In the networked standby mode, your appliance
■
requires a maximum of 2 W.
Press and hold the
#
1.
time until the and
D
Tap the + symbol to start automatic login to your
2.
home network. and
D
Press the WPS button on the router within the next
3.
2 minutes.
Once the connection to your home network has
been established, the extractor hood will connect to
the hob automatically.
The connection process is complete when the
indicator stops flashing on the control panel and
remains continuously lit.
Note: The connection can only be established when
both appliances are connected to your home network
and are in search mode. If the time allowed for search
mode has already expired for one of the two
appliances, start the search again.
Resetting the connection
You can reset the connections you have saved on your
home network and on the hob at any time.
Press and hold the and
#
until a signal sounds.
Declaration of Conformity
Constructa Neff Vertriebs-GmbH hereby declares that
the appliance with functionality meets the basic
requirements and other relevant provisions of Directive
1999/5/EC.
A detailed R&TTE Declaration of Conformity can be
found online at www.neff-international.com among the
additional documents on the product page for your
appliance.
Connecting to a hob en
symbols at the same time
˜
symbol.
#
and symbols at the same
˜
indicators start flashing.
Ù
will flash.
‚
and will flash.
D „
D
symbols at the same time
'
7